Welcome to the Corvette 5th Generation Help site for DIYer's. We hope to provide up to date information, How To's, MOD ification help and ideas, New Product Information and Links to Corvette Resources on the Internet.

Reset Fuel Cutoff Issue

Symptom - Pull Key wait 10 seconds and/or Fuel Cuts off after 2 seconds when trying to move the car.

1) Turn on the ignition but don't start the engine.

2) Press the "RESET" button to turn off any warning messages

3) Press and hold "OPTIONS"

4) While holding "OPTIONS", press "FUEL" four times within a 10-second period.

Initially, on-board diagnostics go into an "Automatic Mode" which shows diagnostic codes in a pre-set sequence: PCM - TCS - RTD - BCM - IPC - RADIO - HVAC - LDCM - RDCM - SCM - RFA. All codes will be displayed for each module. If none are present in a given module, you will see "No More Codes" on the display.

To exit the diagnostic mode at any time, press "E/M". If you want to erase codes in a given module, press "RESET".

To reset the codes once in manual mode, press and hold "RESET" until it displays "NO CODES". Press "OPTIONS" to go to the next module. Repeat the steps until you have reset the codes in all the computer modules.

Key back off, remove fuse #25 and wait 10 minutes before re-installing it.

Install the fuse, bring key back to On and all messages should be cleared as well as the fuel cut-off. If you still have problems repeat the above except this time remove fuses #25 and #29 for 10 minutes. Repeat again and it should be good to go.

Contact Information

mailto: C5help.com

Postal address

2701 Quebec Drive Corpus Christi, Tx. 78414

Electronic mail

General Information: icuall@c5help.com
Webmaster: icuall@c5help.com